Description
SI-1, SI-2, SI-3 Ink Gages
These Ink Gages are smaller ink gages and are considered a general ink gage as part of this family of gages. These gages are available in Stainless Steel 440-C, Chrome Plated Tool Steel and Tool Steel. Comes with a 440-C A-1 Scraper. Get $50 off Long Form Certification when purchased online through our website! ** see below Important: This item is not in stock. Please allow approximately 6 weeks before delivery.
| Model | Block Size (H x W x L) | # Paths | Paths Sizes | Scale | Range |
| SI-1 | ½” x 2 ½” x 8″ | 2 | ½” x 6 ½” | NPIRI Microns | 0-10 0-25 |
| SI-2 | ½” x 2 ½” x 8″ | 2 | ½” x 6 ½” | NPIRI Microns | 0-20 0-50 |
| SI-3 | ½” x 2 ½” x 8″ | 2 | ½” x 6 ½” | NPIRI Microns | 0-30 0-75 |
| * Block sizes are approximate. * Though one micron equals .00003937″, we have rounded off to .00004″ for Calibration. Note: All gages, scrapers, applicators and wedge plates should have rust inhibitor on them when not in use. |
Custom grind gage ranges, path sizes and block sizes are also available. Please call (937)866-9666 or send an email to info@pgtgage.com for a custom grind gage quote.
** If your purchase includes certification and your need a certification interval other than once a year, please specify the interval in the “Notes” section during checkout. Also, please use this same “Notes” section at checkout if you would like to specify your own ID# to be engraved on your purchase where applicable.
